Scope skins
Wondering about the scope rings/mounts, in the video you do not take the rings off and just skin over them. Is this the recommended way? Can you take the rings off, skin the scope and then place the rings back on the scope over the skin or will the rings mess with the skin? I assume that it might mess with the zero and tolerance?
-
Official comment
Most people have their scopes configured just the way they like it prior to installation, so it makes sense to wrap over the top of the mounts and put the scope back on the rifle in the same position.
However, some people have wrapped the scope and the mounts separately and installed them again, with the vinyl under the mounts. It will likely rub the vinyl depending on how hard you tighten the mounts, which may lead to early wear. The vinyl is 6/10 mm and for some it would be easier not to install any hardware on top of the vinyl.
Comment actions
Please sign in to leave a comment.
Comments
1 comment